Model 44 problem

This is an area for guests to post questions

Moderators: Regnier (gunrunner), JohnK, Sure-Shot, Marlin

Forum rules
I have unlocked this forum but made it read only for non members -- Webmaster --
Post Reply
Jfky
Beginner
Posts: 1
Joined: Thu Aug 29, 2019 7:20 am

Model 44 problem

Post by Jfky »

I just bought a model 44 two barrel set. Problem is that it does not rack after the hammer fall. It will rack normally if I use the release. Do I have a simple problem? I have not taken it apart. Anyone have this problem before?
Regnier (gunrunner)
Distinguished Expert
Posts: 4667
Joined: Sun Oct 27, 2002 2:33 am
Location: The Sunflower State

Re: Model 44 problem

Post by Regnier (gunrunner) »

Jfky;

You do not have a problem. Marlin shotguns were specially made with what was called a "Hang Fire Safety" in that the action could not be opened unless the gun was fired. If there was a hang fire, or if the gun needed to be opened without firing, then the safety release must be activated in order to open the action.
Due to the increasing cost of ammunition, there will be no warning shot!

The growing federal deficit = generational slavery to the national debt.

If the world was perfect.......it wouldn't be.
Post Reply